Multiple Boot Environments
(Sorry for the inconvenience)
Beginning with version 9.1, PC-BSD supports multiple boot environments (BEs) on systems that were formatted with ZFS during installation. In 9.1, this feature is managed from the command line. Version 9.2 will provide a graphical interface for managing boot environments.
is a feature originally created by Solaris. By default, the root of a ZFS filesystem is considered to be a BE, since you can boot into it. Multiple boot environments allow you to create additional BEs, or bootable, point-in-time snapshots of the root ot the ZFS filesystem. By booting into an alternate BE, you return to that point in time in the filesystem. For example, if you create a BE before upgrading, you could configure the system to boot into that BE should the upgrade fail and you wish to return to what the filesystem looked like before the upgrade. Alternately, you could create a snapshot BE to install and configure some software that you wish to test. Simply boot into that BE and perform your test installations. When you are finished your tests, set the system to boot back into the original BE.
Understanding Boot Environments
Read this section before using multiple boot environments so that you understand what will and will not be preserved when booting into an alternate BE.
Managing Boot Environments
BE's are managed with the beadm command which must be run as the superuser. The following example creates a BE named beforeupgrade. The new BE is a clone of the current BE, the ZFS environment that you booted into.
beadm create beforeupgrade Created successfully
To view all BEs, use the list command
beadm list BE Active Mountpoint Space Policy Created default NR / 6.05G static 2012-07-09 05:06 beforeupgrade - - 1K static 2012-07-10 12:25
The possible flags in the Active field are as follows:
- R: active on reboot
- N: active now
- -: inactive
In this example, the current BE is called default, it is active now and at next reboot, and is mounted. The newly created beforeupgrade BE exists, but is inactive and unmounted. To activate the new BE:
beadm activate beforeupgrade Activated successfully beadm list BE Active Mountpoint Space Policy Created default N / 64.5K static 2012-07-09 05:06 beforeupgrade R - 6.05G static 2012-07-10 12:25
The flags now indicate that the system is currently booted into default, but at next boot the system will boot into beforeupgrade. Only one boot environment can be active at a time.