Install a Server/9.2
(Sorry for the inconvenience)
The System Selection Screen of the PC-BSD® installer can be used to install TrueOS®, a FreeBSD-based server operating system, rather than a PC-BSD® desktop operating system.
- PBI Manager, the command line version of warden, and the command line versions of most of the Control Panel utilities. You will find those utilities in /usr/local/bin/pc-*. It also installs this of additional shells and utilities. : adds the following to a vanilla installation of FreeBSD:
For a server installation, using the PC-BSD® installer rather than the FreeBSD installer offers several benefits:
- the ability to easily configure ZFS during installation
- the ability to configure encryption during installation
- the ability to configure ZFS Multiple Boot Environments
- a wizard (described in this section) is provided during installation to configure the server for first use.
To perform a server installation, start the PC-BSD® installation as usual. When you get to the System Selection Screen of the installer, click the left arrow until either FreeBSD or TrueOS® is selected. In the example shown as in Figure 5.1a, the user has selected TrueOS® and the FreeBSD option is to the left of the selection.
Once selected, press "Next" to start the "Server Setup Wizard". The wizard is the same for either a FreeBSD or a TrueOS® installation.
Input and confirm the root password which will be used for administrative or "superuser" access to the server, then click "Next" to proceed to the screen shown in Figure 5.1c.
For security reasons, you should not login as the root user. For this reason, the wizard requires you to create a primary user account that will be used to login to the FreeBSD system. This account will automatically be added to the wheel group, allowing that user to su to the root account when administrative access is required.
This screen contains the following fields:
- Name: can contain capital letters and spaces.
- Username: the name used when logging in. Can not contain spaces and is case sensitive (e.g. Kris is a different username than kris).
- Password: the password used when logging in. You must type it twice in order to confirm it.
- Default shell: use the drop-down menu to select the csh, tcsh, or sh login shell.
When finished, click "Next" to proceed to the screen shown in Figure 5.1d.
Input the system's hostname. If you will be using ssh to administer the system, check the box "Enable remote SSH login". Click "Next" to proceed to the network configuration screen shown in Figure 5.1e.
Use the "Network Interface" drop-down menu to select from the following:
- AUTO-DHCP-SLAAC: (default) will configure every active interface configured for DHCP and both IPv4 and IPv6
- AUTO-DHCP: will configure every active interface for DHCP and IPv4
- IPv6-SLAAC: will configure every active interface for DHCP and IPv6
Alternately, select the device name for the interface that you wish to manually configure and input the IPv4 and/or IPv6 addressing information. When finished, click "Next" to proceed to the screen shown in Figure 5.1f.
If you wish to install FreeBSD source or ports, check the associated box(es) then click "Finish" to exit the wizard.
Click "Customize" if you wish to proceed to the Disk Selection Screen in order to configure the system's disk(s).
If you wish to save the finished configuration to re-use it at a later time, insert a FAT-formatted USB stick and click "Save Config to USB".
Once you are ready to start the installation, click "Next". A pop-up menu will ask if you would like to start the installation now.
Once the system is installed, it will boot to a command-line login prompt. Login using the primary user account that was configured during installation. You can now configure and use the server as you would any other FreeBSD server installation. Theis an excellent reference for performing common FreeBSD server tasks.